agile optical components key features ? small size: 65 x 12 x 5 mm surface mountable with gull wing dc pins gpo rf connector integrated pd (photodiode) for bias and power control 200 kpsi input fiber for tight bend radii high bandwidth fec and super fec compatible zero chirp and chirped modulators in a common package operation over c-band and l-band low drive voltage power penalty without fec: < 1 db (1200 ps/nm) for x5 < 2 db (1600 ps/nm) for z5 the jdsu agile optical components family includes modulators, switches, attenuators and tunable filters. these products provide the basis for spectrally efficient dwdm transmission utilizing dispersion tolerant modulation, channel monitoring, wavelength switching, remote power control and dynamic channel selection. they support a wide range of flexible functionalities at lower operational expenses for the agile optical network. in addition, we have a complete line of tunable lasers assemblies and sub-assemblies in our agile transmission module family. jdsu x5 and z5 single drive 10 gb/s modulators with integrated photodiode are ideally suited for use in long reach (lr)/ very long reach (vr) metro applications as well as in long haul (lh) transmission. the x5 is a fixed zero-chirp solution and the z5 is a fixed 0.7 chirp solution, both packaged identically. the small package form factor makes the x5/z5 compatible with the 300 pin msa transponder footprint. the x5 and z5 modulators operate over the c and l band. their low drive voltages make them compatible with low power dissipating driver solutions such as gaas driver technology. in addition to providing bias control feedback, the new enhanced photodiode is capable of power monitoring for control of the transmitter?s modulated output power. applications msa transponders using tunable or fixed wavelength sources tdm and wdm metro systems with up to 120 km reach long haul (lh) and ultra long haul (ulh) systems (both terrestrial and submarine) alternate modulation schemes including electrical rz compliance telcordia 468 x5 and z5 modulator north america : 800 498-jdsu (5378) website : www.jdsu.com worldwide : +800 5378-jdsu
2 x5 and z5 modulator dimensions diagram (specifications in mm unless otherwise noted.) .1 0 ( 2. 6 ) 3 . 84 ( 9 7. 5 ) . 002 ( 65 0 . 05 ) 1. 000 ( 2 5 . 4 ) 1.2 99 ( 33 ) .1 92 . 004 ( 4. 86 0 . 1 ) # 2- 56 u n c -2 b ` .11 8 4pl ou tp ut . 309 ( 7 . 8 4 ) 2x . 0 7 9 ( 2 ) 2 x 2.4 5 ( 6 2. 2 ) . 002 3 0 . 05 ) . 30 ( 7. 6 ) .1 0 ( 2.4 ) 2 x r . 59 ( 1 5 ) min. bend radi us 2 00 kp s i fibe r 1.1 81 ( 30 ) .7 80 ( 1 9 . 8 ) .2 3 ( 5 . 8 ) .1 9 ( 4.7 ) o 2pl .2 6 ( 6 . 6 ) g p o rf p o r t inp ut .47 ( 12 ) .7 3 ( 1 8 . 5 ) 5 4 3 2 1 detail d pinout pin description 1 rf input 2 gnd 3 dc bias 4 pd anode 5 pd cathode
3 x5 and z5 modulator s21 -6 -5 -4 -3 -2 -1 0 1 0 5 10 15 20 frequency [ ghz ] s21 [ db ] (key feaures: er >15 db, jitter p-p <13 ps, measured with optimized driver set-up) eye diagram 0.0 10.0 20.0 30.0 40.0 50.0 60.0 70.0 80.0 90.0 100.0 110.0 120.0 130.0 140.0 0.9 0.8 0.7 0.6 0.5 0.4 0.3 0.2 0.1 0.0 -0.1 ps volts -30 -25 -20 -15 -10 -5 0 0 5 10 15 20 frequency [ ghz ] s11 [ dbe ] s11
4 x5 and z5 modulator specifications parameter x5 z5 chirp (alpha parameter) typical 0 0.7 optical insertion loss (bol) 1 typical 4.5 db optical return loss (input and output ports) typical 40 db optical on/off extinction ratio low frequency typical 27 db prbs 2 typical 15 db e/o bandwidth (-3 db electrical, linear fit 2 to 15 ghz) typical 12 ghz s11 (130 mhz to 10 ghz) 10 db drive voltage (rf port) 3 typical 5.5 v 4.5 v v bias port at 40 khz typical 4 v 2.5 v bias voltage range 4 typical -15 to 15 v rf port resistance (dc) typical 40 ? bias port resistance (dc) typical 1 m ? photodetector extinction ratio 5 typical 6 db photodetector o/e bandwidth typical 100 khz photodetector responsivity (referenced to output power) typical 20 ma/w photodetector phase tracking error 6 typical -5 to 5 photodetector dark current (at -5 v, room temperature) typical 5 na ? r/ ? t 7 typical 0.2 db ? r/ ? 8 typical 0.3 db 1. measured at peak of dc bias transmission with no rf input and no optical connectors. 2. for prbs signals of up to 2 31 -1 and bit rates up to 12.5 gb/s. measurement is based on an optimized test set up. 3. maximum driving voltage required to achieve 15 db er for 12.5 gb/s 2 31 -1 prbs signal over the operating wavelength and temperature ranges. 4. maximum voltage range required to maintain optimum bias point over life and temperature. 5. er = 10*log(i max /i min ): i max = pd current with modulator biased to maximum output power, i min = pd current with modulator biased to minimum output power. 6. tracking error is the difference in phase between the modulator ou tput power transfer function and the photodetector output c urrent transfer function. 7. the change in responsivity with temperature can be improved from the values given by employing passive thermal compensation. 8. over c or l band. this can be calibrated for a given laser frequency.
north america : 800 498-jdsu (5378) website : www.jdsu.com worldwide : +800 5378-jdsu telcordia is a registered trademark of telcordia technologies incorporated. all statements, technical information and recommendations related to the products herein are based upon information believed to be reliable or accurate. however, the accuracy or completeness thereof is not guaranteed, and no responsibility is assumed for any inaccuracies. the user assumes all risks and liability whatsoever in connection with the use of a product or its application. jdsu reserves the right to change at any time without notice the design, specificatio ns, function, fit or form of its products described herein, i ncluding withdrawal at any time of a product offered for sale herein. jdsu makes no representations that the products herein are free from any intellectual property claims of others . please contact jdsu for more information. jdsu and the jdsu logo are trademarks of jds uniphase corporation. other trademarks ar e the property of their respective holders. ?2006 jds uniphase corporation. all rights reserved. 21029448 rev. 006 04/06 x5z5.ds.cc.ae ordering information for more information on this or other products and their availability, please contact your local jdsu account manager or jdsu directly at 1-800-498-jdsu (5378) in north america and +800-5378-jdsu worldwide or via e-mail at customer.service@jdsu.com. x5 and z5 modulator sample: 21049397 product code description 21049397 10 gb/ s x5 ,s c/upc ou t pu t c o nnect or 21049396 10 gb/ s z5 ,s c/upc ou t pu t c o nnect or
|
